Proper Use and Maintenance Measures of Roll Crusher
2016-05-11
Proper Use and Maintenance Measures of Roll Crusher
Roller crusher is a kind of stone crushing plant which is widely used in many industries. In order to ensure that the roll crusher to maximize the crushing capacity, we need to operate roll crusher in the correct use and maintenance methods.
roll crusher
1) Before starting the equipment operator, we shall conduct a comprehensive inspection equipment, including various parts of the bolt, the gear unit and bearing lubrication oil.
2) stone crushing plant machine should load starting to reach normal operating speed and no exceptions can begin to feed. Normal shutdown preceded stop feeding, to be ranked in order to shut down the net after crushing chamber materials, except in special circumstances. Not allowed to bring the load to start.
3)before the start of long-term disabled or respond roll crusher conduct a comprehensive inspection to see whether the bolts loose, whether injection to meet the requirements within the deceleration machine, plenty of oil, whether to join the bearing grease, wiring electrical wiring and control switch if correct, whether at the loose wiring, whether material crushing chamber has been cleared. After confirmation, jog start crusher, observing the rotation direction of roll crusher is correct, then being officially launched.
4) found in stone crushing plant machine abnormal noise, drive unit, occurs when abnormal temperature rise of the oil or smell the odor, should be shut down, identify the cause and eliminate the fault before the restart.
5) roll crusher motor bearings, main bearing should be cleaned up once a year; reducer annual clean-up, oil change 1 time.
6) When overhaul the roll crusher, first cut off the power, and hang out repair mark, to ensure the safety of maintenance personnel.
7) stone crushing plant machine running three months after re-tighten a fastener response times, and regular repair and maintenance, including weekly inspection, monthly inspection, annual inspection.
Removing the body after maintenance, when re-assembling, must be uniformly coated with sealant joint surface and still combine the upper and lower bearing surfaces of the body, in order to prevent the sealing surface of the oil spill.
Hot Product
